What do we Check with our Preventative Maintenance Service Plans?
It varies depending on the type of system you have; for a more complete list Click Below:
For a Typical Heat Pump Checklist as follows:
OUR HEAT PUMP TUNE-UP PROCEDURE INCLUDES:
- Clean and thoroughly wash condenser coil(s).
- Wash and level condensing unit for proper motor and bearing wear.
- Apply weather resistant coating to the outside unit. (condenser)
- Clean and inspect evaporator coil and drain pan when readily accessible.
- Clean and inspect condensate drain lines and fittings.
- Inspect system electrical wires, connectors, and terminals.
- Inspect electrical connections. This includes service disconnect switch.
- Test controls, switches, relays, transformers, contactors, motors, and fans.
- Test capacitors.
- Measure amperes, line voltage, and control voltage.
- Inspect blower compartment, blower motor, wheel, and clean as necessary.
- Monitor refrigerant pressures.
- Replace or clean standard 1” air filters.
- Inspect supply and return duct system.
- Clean and test thermostat.
- Report any problems, and make necessary recommendations.